Distribution Panels & Busbars

No description available.

No description available.

- Provides compact high-ampere busing with 3/8" terminal studs

Insulated single stainless steel stud terminates multiple large conductors - Connects high amperage cables securely - Stud dimensions: 3/8" x 7/8" - Base Material is PBT UL94 V0

Enables connection of multiple smaller wires in spaces where a traditional bus bar may not fit - 150 Ampere bus allows small wire connections at high amperage cable connections - Connects high amperage cables securely - Stud dimensions: 5/16" x 3/4" - Base Material is Black Nylon 8231 GHS

An ignition protected fuse block with screw termination safe for use on gasoline powered boats - Accepts four AMI® or MIDI® Fuses for high-amp circuits up to 200A - Accepts six ATO® or ATC® Fuses for circuits up to 30A including bilge pumps, electronics and lights - Sealed cover protects fuses from the harsh marine environment and satisfies ABYC/USCG insulation requirements - Negative bus provides common location for negative connection - Circuit identification label with write-on capability - Fuse puller easily removes ATO® or ATC® Fuses - Cover provides storage space for two spare ATO® or ATC® and two spare AMI® or MIDI® fuses and mounting screws - One-piece stainless flange nuts ensure safe and secure connections - Fuses sold separately

- Easy to install 4 ATO®/ATC® fused circuits - Mounts on the battery terminal stud - Screw terminals for securing wires - Four Nylon insulated ring terminals included - Insulating cover included - Accepts Small Format Circuit Labels - Includes 1 fuse

- Corrosion resistant, tin-plated copper fuse clips reduce heat and improve the efficiency of the electrical system - Accepts ring or snap fork type terminals - Includes two terminal block jumpers

- Closed back design completely insulates power from the mounting surface - Each screw pair is one isolated circuit - Jumpers allow creation of common circuits

- Closed back design completely insulates power from the mounting surface - Each screw pair is one isolated circuit - Jumpers allow creation of common circuits

- Closed back design completely insulates power from the mounting surface - Each screw pair is one isolated circuit - Jumpers allow creation of common circuits

- Red reverse polarity indicating LED - All hot, neutral and safety ground buses installed, fully pre-wired - All circuit label positions are backlit on standard panels - No kit required - "ON" indicating LEDs installed in all circuit positions

Easy to install accessory panels include a 15A circuit breaker switch and pre-wired harness. Panels offer customizable 12V charging and monitoring options. - Pre-wired harness included in all panels for easy installation - Silicon breaker boots and gasket protects against water ingress - Illuminated Carling Technologies 15A circuit breaker switch allows the ability to shut off panel preventing parasitic draw - Polycarbonate/ABS panel face is UV-stabilized, flame retardant, and will not corrode - 12V DC only